Parallel Installation of ROSETTA3.1

Member Site › Forums › Rosetta 3 › Rosetta 3 – General › Parallel Installation of ROSETTA3.1

  • This topic has 1 reply, 2 voices, and was last updated 15 years ago by Anonymous.
Viewing 1 reply thread
  • Author
    Posts
    • December 8, 2009 at 5:09 am #416
      Anonymous

        Hi,

        I want to install ROSETTA3.1 in a parallel environment, to make it run
        on 16 processors through MPI. Should I use the following command for installation:

        scons -j16 bin mode=release

        Please advice.

        Regards,

        Anirban

      • December 8, 2009 at 2:39 pm #4270
        Anonymous

          To compile rosetta for MPI, you need to add extras=mpi to that command line:

          scons -j16 bin mode=release extras=mpi

          If MPI is installed it should go smoothly from there. The job distributor detects that it is compiled in MPI mode (via #ifdef) and will run in parallel automatically. I’m not sure that every application properly supports MPI, though.

      • Author
        Posts
      Viewing 1 reply thread
      • You must be logged in to reply to this topic.