Member Site › Forums › Rosetta 3 › Rosetta 3 – General › symmetric Docking- TRIMER in Rosetta 3.4 ?
- This topic has 1 reply, 2 voices, and was last updated 12 years, 4 months ago by
Anonymous.
-
AuthorPosts
-
-
April 12, 2012 at 11:22 am #1232
Anonymous
I need to do certain symmetric docking to generate its homodimer and homotrimer and I am using Rosetta 3.4 Symmetric docking to achieve it.
I used the following command to generate homodimers :
./bin/SymDock.linuxgccrelease -docking:dock_ppk -symmetry:symmetry_definition ./sym_def_dimer.dat -symmetry:initialize_rigid_
body_dofs -database ../rosetta_database/ -out:nstruct 2 -out:file:fullatom -s S_00000001.pdbI used to use the older version of Rosetta i.e Rosetta++2.1.2 where I used the following comman to generate homotrimers but now I use rosetta 3.4 and can’t find its equivalent.
./rosetta.gcc64 a1 t000 _ -dock -symmetry -n_monomers 3 -nstruct 500 -s
s0000678n_monomers 3 : This enables us to generate homotrimers but the new Rosetta 3.4 does not have this option.
I will be grateful if you could help me with the proper command that would help me generate homotrimers from single monomeric unit(i.e PDB files) in rosetta 3.4 especially more so because I want to avoid using “fold and dock” instead.
Please advise
-
April 12, 2012 at 6:29 pm #6966
Anonymous
Hopefully someone else with more knowledge of symmetric docking will be along to help, but from the limited amount I know about symmetry in Rosetta3, the type of symmetry is specified in the symmetry definition file. (See http://www.rosettacommons.org/manuals/archive/rosetta3.4_user_guide/d1/dd2/symmetry.html along with http://www.rosettacommons.org/manuals/archive/rosetta3.4_user_guide/db/d1b/make_symmdef_file.html and http://www.rosettacommons.org/manuals/archive/rosetta3.4_user_guide/d4/d4a/make_symmdef_file_denovo.html – take another look at http://www.rosettacommons.org/manuals/archive/rosetta3.4_user_guide/d4/dae/symmetric_docking.html while you’re at it, too).
If you wish to do trimeric docking, you need to create and specify a symmetry definition file which defines the trimeric symmetry you want to use, which substitutes for (and is more general than) specifying the number of monomers.
-
-
AuthorPosts
- You must be logged in to reply to this topic.